Staerk Strong As Nails Showers
Staerk Strong As Nails Showers is a solvent based adhesive, formulated for bonding of acrylic plastic shower linings and trays to unpainted gypsum plasterboard, fibre cement wall linings, concrete or timber.
Available Colors
Properties
Easy Spread / Non Staining / Water and Heat resistant / 20y. Guarantee
- For bonding of acrylic plastic shower linings to different type of wall substrates
- Fixing shower trays to floor
- ACRYLIC AND PLASTIC MATERIALS
- WOOD, PARTICLE BOARD, PLYWOOD
- UNPAINTED PLASTER BOARD
- FIBRE CEMENT
High Strength
High tensile strength and forming a strong bond with most building materials is the main feature of this versatile product.
Special Formula
Non damaging or staining to plastics and acrylics and easy to reposition up to 30 min after initial installation.
Strong Grab
Strong initial grab will help with installation, less temporary braces.
20y. Guarantee
Against pealing or crumbling under proper usage. We give the one of the longest and comprehensive guarantees in the industry.
Preparation
The base material need to be free of dust and grease or loose material. If needed clean up with a turpentine wet rag or cloth, after with methylated spirits and let it dry. If necessary can be sanded until the surface is clean. Complete test before use and make sure good compatibility and viscosity of the adhesive with base materials.
Application
Cut off the top of the cartridge, position the threaded adaptor to the cartridge. Cut the threaded adaptor on an angle to achieve needed opening. Place the cartridge into gun and inject 5-6 mm bead in vertical lines at 100 mm centres onto substrate, and apply continuous bead within 20 mm of the perimeter line of the shower lining. Place shower lining onto wall within 10 minutes and press the entire sheet with your hands and brace so that full contact is made with all of adhesive applied. Bracing should stay for at list 24 hours. Do not use the shower for 48 hours after full installation.
Cleaning
Clean while uncured with a turpentine cloth. After hardening removes the adhesive mechanically with a scraper or can be sanded.
- Flammable
- If medical advice is needed have the product container and label at hand
- Read the label before use
- Gloves and goggles must be worn during application
- If skin contact occurs remove the sealant with cloth and wash skin thoroughly with water and detergent for a minimum of 15mins
- Avoid eye contact before curing. If this occurs rinse opened eye for several minutes under running water, then consult a doctor.
- Ensure proper ventilation at the workplace or curing area.
- Keep away from children.
- Protect from freezing, store in a cool dry place below 25 C temperature to prolong its service life.
- Need to be protected from naked flame or high heat sources.
- Product must be used within 24 months of purchase
